S
sweperformance
Member
How can I order it? Cant find anything on the webshop??
Boondocker Timing Module
- Thread starter TheBreeze
- Start date
Do we have any boondocker vendors here on snowest?
give this guy a call
Justin
http://coderedperformance.com/main.html
He's on here too, and is a pretty helpful guy to deal with.
The timing module works great! I have been running one on my M1000 and on the 2010-2011 M8 for the last 4 or 5 rides of the season with great results. On the 2010-2011 we can run the stock head with tighter compression clearance and get away with much lower octane requirements.
We have them on the shelf.
We have them on the shelf.
MM is a good guy to call on turbo stuff no matter what you need.
S
sweperformance
Member
I want more details..! 3 degree retard ignition in what boost?? I hope it works like that, with a boost ref line and retards the ignition with boost?
B
bradburck
Well-known member
Benefits
So what type of benefits can an 09 pump gas see? I've been running 9-10 lbs with 2ish gal of race. Will this help get away with straight 91 at these same levels? 10k feet. I know it won't help duty cycle so the best benefits would just be lower octane at same boost levels?
So what type of benefits can an 09 pump gas see? I've been running 9-10 lbs with 2ish gal of race. Will this help get away with straight 91 at these same levels? 10k feet. I know it won't help duty cycle so the best benefits would just be lower octane at same boost levels?
For the 2010-2011 what kind of boost/octane are you talking and what was the elevation you were running it at?
S
sweperformance
Member
No more info about this module?
T
TheBreeze
Well-known member
I am wondering the same thing. I would think there would be some Boondocker dealers on here, or Boondocker themselves, that would post some information about these units, as there sure seems to be interest out there.
I have one on the way and will post some pictures when it arrives.
I have one on the way and will post some pictures when it arrives.
S
sweperformance
Member
Is it only controlled by RPM? Or is it 3D trigged?
The boost is not the same at a specific RPM, it depends of load.
The boost is not the same at a specific RPM, it depends of load.
B
BDTURBO
Active member
The timing module works very well it take less than 1 min to install or remove we were testing 91 octane non ethenol 2010,2011 head starting at 5500 ft and up in elevation and we were able to run to max inj. duty cycle 96% or so without det if module removed we would make it 50- 100 yrds before det. it is very helpfull in the mid range where it is needed most for the on and of throttle in tight trees or chutes ,it is a prgressive slope based on rmps so somewhere around 2 degree retard at 7000 rmps reaching 3 degrees by 8000 they will also be avail. in 1 and 2 degree as well for turbo or nat asperated. with no sacrifice of bottom end as we are not pulling timing there.
S
sweperformance
Member
Sound like a real good product!
I use a 2.5 timing key now, works fine with boost, but poor without boost. Maybe I should install a 0.5 degree (higher ignition than stock) to get more power and better trottle respons on low rpm? That do you think?
I use a 2.5 timing key now, works fine with boost, but poor without boost. Maybe I should install a 0.5 degree (higher ignition than stock) to get more power and better trottle respons on low rpm? That do you think?
