Running board question (600rr)

[JET FUEL]

If they will fit Pro-X boards I would be interested in a set too.

How much of a PITA is it to drill out those flat rivets on the stock fishbones?

I'm not going to lie, It wasn't the greatest most funnest thing in the world to do, and you won't believe how flimsy the tunnel is without them.But I think the end result is worth the effort.

Be sure and P.M. Carl (meathooker) if you want a set.

Maybe you pro-x guys can get some measurement up so we can see if the fit.

 

[meathooker]

I'm not going to lie, It wasn't the greatest most funnest thing in the world to do, and you won't believe how flimsy the tunnel is without them.But I think the end result is worth the effort.

Be sure and P.M. Carl (meathooker) if you want a set.

Maybe you pro-x guys can get some measurement up so we can see if the fit.

They kept eating drill bits up so we used a flap disc grinder and took off the back side. After we figured that part out it took about 1/2 hour to get ours off (2 sleds).

 

[meathooker]

I started a new post with the details for selling these.

http://www.snowest.com/forum/showthread.php?t=110205

Carl

 

[shortstop20]

I'm not going to lie, It wasn't the greatest most funnest thing in the world to do, and you won't believe how flimsy the tunnel is without them.But I think the end result is worth the effort.

Be sure and P.M. Carl (meathooker) if you want a set.

Maybe you pro-x guys can get some measurement up so we can see if the fit.

I'll see if I can get some measurements on the running boards. I'm sicker than a dog right now so it might be a couple days.

They kept eating drill bits up so we used a flap disc grinder and took off the back side. After we figured that part out it took about 1/2 hour to get ours off (2 sleds).

Good idea, that wouldn't be a problem at all.