impulse turbo nytro starting issues

[DakotaDitchrippers]

i have a 2010 nytro mtx se 162
impulse stand alone system
2871 turbo.
it starts if i unplug the fuel pump fuse. idles till it dies but wont start with fuse in and i need help figuring it out
it starts sometime then wont the next and cant figure out why.

 

[DakotaDitchrippers]

anyone have any ideas

 

[BigFish BC]

sounds like one or more of the injectors are leaking when you have pump pressure,so it floods & wont start till the pump is off.

 

[DakotaDitchrippers]

i did more digging.
i had put new. bar/map sensors on. i replaced them with my old ones. and it has been working fine.
my original good sensors. tested at 13.2 k ohms from ground to sensing and positive to sensing. and 1.3 k ohma from pos to neg.

the set i had new. tested at 17.6 k ohms. and 2.0 k ohms. i believ the incorrect resistence. was senting my system to full rich. flooding me out on start up.

 

[MitchyTheSparky]

Next time call Paul at Impulse He's always super helpful

Sent from my XT1080 using Tapatalk