Front track shock mounting

[907assault]

I searched and searched but got nothing.

Lower mount for front track shock, with the spacers and shaft.

What are the thicknesses for the inside washers between rails and spacers?

Do these allow the spacers to not get tight when the shaft is torqued?

Do the washers O.D. Need to be small enough to be able to slide inside of spacer I.D.?

Any help is appreciated

 

[mountainhorse]

The washer you are referring to... #27 in the suspension drawing below, is .105" thick.

There should be the same washer under the bolt that holds the secondary on, Part number 7555832, Reference number 15 in this dwg below.
I say "should" because these washers are used as shims.....so measure which one comes out to .105" thick if you are taking it in for comparison.
#15 (.105") and #16 (.065) are the two thicknesses of washer used in the clutch... the .105" thick washer is what is used on the ends of the shock shaft.

Pop that one out for comparison.... IMO, a few thousandths either way will not make a difference for the shockshaft mounting.

.

 

[907assault]

Roger that, thanks mountainhorse.

And with the shock shaft torqued, the spacers with anti rotation flats may have a few thou play, correct?

 

[mountainhorse]

easily