2011 PRO A ARMS BENT

[Zbroz]

Ditto here but I didn't have any good lower ones left .

I tell you what though, the stock A arms did their job. One bend was questionable but the other was a rock collision and it destroyed the lower A arm. Even though I couldn't turn left until I beat the A arm with a rock to straighten, everything else was amazingly still straight. I think for sure it would have totaled an XP nun.

I hope the Zbroz will know when to fold 'em too!

Oh, and BTW I was looking where I was going but these rocks, they tend to hind under stuff.

On average our arms are 25% stronger then stock. They are built with this in mind though. We build them as tough as possible without making other parts of the sled the "weak point".

 

[snopro_ac]

On average our arms are 25% stronger then stock. They are built with this in mind though. We build them as tough as possible without making other parts of the sled the "weak point".

can't wait to get out there and bend my first set so i can order a set of zbroz!

 

[allpowersports]

ZBROZ to RMK ASSAULT

Well bent my lower right a-arm on something, I can't even recall hitting something
Does ZBROZ make a-arms to the rmk assault?

 

[snopro_ac]

Well bent my lower right a-arm on something, I can't even recall hitting something
Does ZBROZ make a-arms to the rmk assault?

yeah the 43" ones i think.

 

[GMCRMK]

can't wait to get out there and bend my first set so i can order a set of zbroz!

Don't wait. The ZBROZ are bad azz. Sell your stockers and put the $$ towards the upgrade. You'll "save" money that way. Plus when you do bend your oems you won't be stuck waiting for replacements.

 

[aadougie]

I got a D8 A-Arm - it's gloss black instead of flat black, but my Pro doesn't lean to the left anymore! Note: you have to swap the spherical bearing (#13) and the bushing and pivot mounts (#2,3,&17) - pop the snap ring (#14) and gently tap out bearing - I used a 23mm socket which fit perfectly over the bearing and into the A-Arm...

Aftermarket stuff is great I'm sure, but be sure to check the width of the A-Arms before you order - from what I can tell most of the aftermarket stuff is wider than the stock Pro. Go wide if you want, but take the sway bar out and put your skis in the narrowest position and head for the tight trees one afternoon and you'll never go back! Jumpers and Freeriders need not heed this sage advice - tight woods boondockers should give it a try.

 

[Peevo]

A buddy hit a concrete ring today. He got kicked off and it looked like Charlie Chaplin tried to do a front flip. It's sick that nothing else than the a arm broke.