So my RMK 800 had a really bad knock in the motor.. got the motor pulled and apart tonight.. Found the rod on the PTO side got stretched a little or the bearing just went bad where the rod meets the crank.. every 1/4 turn the rod snaps back and forth.. Whole crank n all still spins free, just has a BAD noise.. Seems to be the only problem.. That side piston has a few scratches in the side and front and has some gouges on the top, but there is no damage to the piston rings or the cylinder, which I found somewhat odd.. Well I know I am going to need crank work and want to make sure I am not pulling this thing apart again in the future so I am wanting to get the crank fixed/replaced, have the wide bearing kit installed and of coarse put new pistons, rings and gaskets/seals in it.. I am doing all the work myself with the installation of everything, just trying to get an idea of how much the parts are going to cost.. I need to go as cheap as possible, but still have quality.. From someone who has done this, any ideas on price and a good place to purchase what I am needing? Thanks for any advice