Zolinger spindles and zbroz 36" front
- Thread starter ullose272
- Start date
But the Zbroz Spindles are designed to clear without modification.
I liked the look of the zrp ones better. But i dont want to grind on them so i might end up with the zbroz. Plus i thing the zrp ones are a little cheaper
Sent from my SM-G900V using Tapatalk
True.. I agree they look better as well and are cheaper. Hate to grind on such a pretty piece!
ZRP's match stock. So if the arms work with the stock spindles then they will work with the ZRP's spindles. We're not sure why you have to use a grinder to install so many of ZBroz's products.
If our spindles don't fit as is we can send them to you before we have them anodized, so you grid them as needed, then send them back to us and we will get them anodized so they look stock and not cut up.
Just hit us up at http://www.zollingerracingproducts.com/ if you're interested in doing that.
If our spindles don't fit as is we can send them to you before we have them anodized, so you grid them as needed, then send them back to us and we will get them anodized so they look stock and not cut up.
Just hit us up at http://www.zollingerracingproducts.com/ if you're interested in doing that.
Hard to get in there for a good pic, but this gives you an idea of how much I had to grind with zollinger spindles and Kmod front end. Pretty easy.
