• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

Which Aftermarket Suspension is best: K-Mod, Timbersled, EZ-Ride, TeamFast?

If you were going to change out the rear suspension, which would you buy??

  • KMOD

    Votes: 124 33.7%
  • Timbersled

    Votes: 111 30.2%
  • EZ-Ryde

    Votes: 62 16.8%
  • Team Fast

    Votes: 10 2.7%
  • CR Racing

    Votes: 27 7.3%
  • Racer's Edge

    Votes: 23 6.3%
  • Nextech

    Votes: 11 3.0%

  • Total voters
    368
Thread Rating
5.00 star(s)
Last spring my Fox floats weren't rebounding and would occasionally stick down. I finally pulled them to check them out and so far they look alright on the inside. The spherical bearings on the top were froze up, and the lower bar for the front shock was bent a little. Other than those minor issues, my Timbersled has held up fantastic. The only hiccup ive had while riding was my own fault, I blew out a rear wheel when I landed a little sideways. I made it back to the truck, but had to replace the wheel. Oh I also broke one limiter strap, but haven't had an issue since then.

Sent from my Commando
 
My timbersled performed well but buckled my tunnel ..I called and they said I must have bottomed it out?
Im must ride harder than the average snomobiler I guess
 
My timbersled performed well but buckled my tunnel ..I called and they said I must have bottomed it out?
Im must ride harder than the average snomobiler I guess

How much psi were you running in your shocks?
 
My timbersled performed well but buckled my tunnel ..I called and they said I must have bottomed it out?
Im must ride harder than the average snomobiler I guess

Let me guess stock tunnel with timber sled drop brackets!!
Ask me how I know.
 
Its interesting to watch the POLL over the years.
Slowly but surely KMOD is creeping up on Timbersled's numbers.
 
So Im on the KMOD wagon. Kevin can give me dimensions referencing OEM hole locations. However, I don't have an OEM tunnel, and am unsure of where my current suspension is located in relation to this. Any of you KMOD/NYTRO guys got a measurement (edge of bulk head or center of driveshaft and down from top of tunnel) to center of either the OEM hole or the new hole? I don't know anyone who has an OEM one of these I can go measure off of to get this project moving.
 
What ever happened to EZ Ryde?
I thought that is what the guys in the hillclimb circuit run?
 
Premium Features



Back
Top