Just so you all know, if you have anything to say/ask of me you need to PM me now! I'm out of viewing privileges! ![Wink ;) ;)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
It's not what Vipec can do, but what it can't. By installing Vipec you are taking ownership of the entire engine management system.
Wich is super!
The installer better be very confident in the tune before sending a customer out on the snow with no way of making adjustments.
that is EXACTLY what we are giving you guys.....adjustments, all of them. all the requiered tuning infrastructure is now built,boosted or N/A......Next season, ALL of the Vi-pec family vendors will have gone through a complete E.F.I. class making them super comfortable with EFI tuning and requierements for a good running EFI machine.
Skadis sled might be the first of many.
This is so much crap....i am respecting your reserves toward our ECU but don't go to far with your comments ok? so far i think we didn't make that bad if that is what you are insinuating......
that's it for me too on this thread, like r_8_n wants.
She already got another sled. 12 with a RKT 858.![]()
Like Precision EFI said, were just the one in the spot light right now. Lots of sleds working well with it. we saw something that we thougth would make her sled run way better....which it did...but having 1800 miles on the sled already we should of put a new top end on it. I had my TD8 go down after 1100 miles last winter. 1800 was pretty good i think. Anyway....the ONLY reason of selling the vipec is to recoup some money for summer toys. we've already been talking about putting a vipec on the RKTech 858 that shes getting but that wouldnt happen till next fall.
It is intersting that you guys are pushing this product so hard when it's not even ready to go? If you look at all the posts then it is always what it is capable of or what it will do or if you do this or that.The Det sensor is working, we just have to do final calibrations and also the installation as of now will be plug and play the whole nine yards. So unless yours will add and subtract timing, have 3/4/5 D fuel and ignition maps, full configuration, individual cylinder trim(which is needed), full EBC control for consistencty,full altitude compensation , troubleshooting capabilty(very important for electronics and sensor standpoint,even more than digital wrench), Dwell control, injector timing control, and the list goes on. Like I have said time and time again,the Boost-it works well but doesnt have near the capability. The Vi-pec will have to be fine tuned by each individual because of fuel pressure variation and engine flow characteristics which will consist of maybe 1 day of tuning and after that its done from low to high elevation and zero to whatever kpa boost. Basically what it comes down to is one fuel table of tuning for 99% of people, less work than a power commander. Then if you want to add crazy configuration stuff to the combo be my guest like launch control,anti lag, etc. The whole principal behind the product is consistency and after its set you dont touch it. By next fall the kit being released will be plug and play from 0 to 13 pounds of boost and sea level to 13000 ft elevation.![]()