Trueing a crank

[m8magicandmystery]

I have now gotten the PTO end on the very tip down to 0.0015" movement in a full rotation. But on the bearing race closer to the web it is out 0.0035"-0.004" movement. How could one fix that?.

can ya machine the brg race area true for that little bit and use a brg set loctite..???

 

[ippielb]

ps...are ya going to pin and weld it or is it just going to go out again fairly quick...??

Was going to try and see how this works out before I weld it. I am not too worried about taking it out and rippin the engine apart.