I built a bracket out of aluminum tubing and a tab that relocates your handwarmer switch onto your riser. A very easy build and install i had one on my 08 and now on my 09.
Trouble getting your left hand throttle and your handguards on your handlebars?
- Thread starter keller98x
- Start date
more pictures
My bike water bottle holder it keeps the water in a slush form
My bike water bottle holder it keeps the water in a slush form
I moved all my crap off the bars on my zx, but that is a clean way to do that and keep the plastic intact. That water bottle holder is slick, although you might end up with some pretty warm water!
Surprisingly enough the water or gatorade whatever you use doesnt get warm it sometimes freezes if your not riding hard but it normally just keeps the water at a slush content
I think ceramic coating the pipes probably keeps the engine bay temp down enough so the water get too warm.
who's lefty is that and what was the price. I was going to go with a Goldfinger this week.
Its made by snow-bunji i had a goldfinger and hated it went with a snow-bj and never went back..........its 120 bucks-i got mine at haydays
if you have the older bars, just attach em on the side, or be cheap and just ziptie the controls to the riser, seen it done a time or two.
i think the biggest benefit i see is that i dont turn my high beams and handwarmers on all the time without. and you help lessen the risk of snapping the buttons off, i broke my reverse button off my old sled, still had the button mount, it was just really hard to push.
i think the biggest benefit i see is that i dont turn my high beams and handwarmers on all the time without. and you help lessen the risk of snapping the buttons off, i broke my reverse button off my old sled, still had the button mount, it was just really hard to push.
Thanks I will look into this one.
