U
I run a 2008 twisted M1000 and I am just switching my PG attitude box over to my PG/RG box and I had a few questions. I see there are two new black connections which look like they goto the new injecters and a red wire. I assume the red wire needs to be powered for the new injecters is that correct? On my PG attitude box there were two other connections that went to the two blue plugs. One was for the air sensor and the other blue plug in the ecu. These two connections are not on the new PG/RG box. So how do I hook up my air sensor and the other blue plug on the ecu?
Which wire do you tie into for the water temperature switch. Do I just splice inline to the yellow wire?
Thanks
Which wire do you tie into for the water temperature switch. Do I just splice inline to the yellow wire?
Thanks