Sno Bunjie placement

[couch]

Trying to find a decent spot to add a son bunjie to the 2013 pro .... despite the post of some its likely that the sled will get stuck occasionally and a lll sleds are heavy when stuck in certain conditions ....
Considering hooking end into the back tunnel / board support with a hook for the handle by the back bumper. Slickest mount was the guy with the rev with the bunjie slid into a pipe down through the hood ... doesn't seem to be easily possible on the pro ...

Where / how have you mounted a bunjie? Pics would be greatly appreciated ...

 

[sledheadd]

I wrap mine around the seat brace and hook it to its self no extra tie down needed.

 

[longlugs]

x2

 

[Drewd]

Mine is in my powderkeg tunnel storage container. If I didn't have it in there, I'd probably rivet/fab something so I could store it on top of my tunnel.

 

[sledneck_03]

Guys in my group with the dual hook one wrap their rear bumper and hook to their gas rack.

 

[superdoo]

Mine is in my powderkeg tunnel storage container. If I didn't have it in there, I'd probably rivet/fab something so I could store it on top of my tunnel.

the powder keg for the pros is just right size, i keep mine there too. that keg is a great product for the pro's.

 

[couch]

I wrap mine around the seat brace and hook it to its self no extra tie down needed.

I have an undersea bag on the sleds so there is not enough room to loop around the brace ....
I have a simple / light tunnel rack (thin wall ss tube) to hold extra gas & kit bag so that spots unavailable as well ....

Thanks for the ideas / suggestions ....

 

[Reg2view]

Under the webbing on a mountain addiction bag.

 

[revyg]

Polaris shovel bag, fits perfect, I have the two hook model.

 

[05900]

Ski loop to Ski loop.............yes I saw it and got the hell away from them.

 

[Assault-7c]

Great post!! I was wondering this very same question. I have the sled to sled bunje and on my Assault, I had it hooked to my bumper than under the seat brackets and then hooked back on the bumper brackets. The problem with this was it constantly rubs on the tunnel. With my new 14, I wrapped the entire tunnel and don't really want to see it rub the tunnel.

 

[catssuk]

i just have mine around a large mtn addiction bag and just hooked to my gas rack,its been there for 500 miles so far holds great

 

[wjl]

Handle snow bungie fits in my under the seat bag. I would think the sled to sled one would too.

 

[rrjames]

I wrap mine around the seat brace and hook it to its self no extra tie down needed.

I am so embarrassed that I did not think of that...so simple time to get that thing out of my backpack.

 

[beamslayer]

I always let my riding partner carry it .

 

[rrjames]

I always let my riding partner carry it .

tried that, he didn't go for it. I then tried to argue that the only reason I have it is because of him...

 

[KStrand]

Hook around gas can rack and around and under shovel neck and then the bunjie handle into the shaft of the shovel handle. Best way i found and easy to access when pulling out the cats and doo.

 

[NapaMatt]

Ended up with the SKINZ Bag In front of the Seat supports.. Finagle it in there then sliding a Saw fouled by as many water bottles I can shove in ~ Give or take 3-4 Fills the Bag.

 

[RMKNV]

I used a p-clamp and "D" ring on both sides and a couple of reusable twist ties on the corners of the bumper to hold it in place. I also looped it through a soft tie for quick hook up.

 

[MOWER800]

simple