Quick Drive belt the same?

[JUDGED]

Axys Quick Drive Belt the same as the Pro Chassis? I have a 13 pro and ride with 2 others, but spring checker an axys. Want to start carrying a spare and hoped it would work on all our sleds.

 

[sledheader]

Given that the axys is a different ratio, I doubt the belts will be the same.

 

[SRXSRULE]

The new belt is 2 teeth longer. Eric

 

[LoudHandle]

The new belt is 2 teeth longer. Eric

Eric, am I correct that the old was 68 Pitch and the new is now 70 Pitch / tooth?

 

[SRXSRULE]

Eric, am I correct that the old was 68 Pitch and the new is now 70 Pitch / tooth?

That is correct.
What I want to know is if the Center to Center distance of the jack to drive shaft has stayed the same. Would be an easy way to gear down the 16 using the gears and belt off the 13-15. Eric

Eric

 

[LoudHandle]

That is correct.
What I want to know is if the Center to Center distance of the jack to drive shaft has stayed the same. Would be an easy way to gear down the 16 using the gears and belt off the 13-15. Eric

Eric

I have no insider information but from the tooth counts is works out to about 200mm center to center. That is 9 mm longer than the PRO chassis (Which was a 191.26mm center to center). I personally wouldn't think of using the stock stuff to try gearing it down. The much higher quality for very little extra cost of the aftermarket stuff is a no brainer in my opinion.

 

[Carls Cycle]

Based off of the measurements of the Axys demo sitting here, the center to center distance of the new sled is 7-3/4 inches roughly, where as the Pro from 2015 was 7-9/16. The new belt is a little longer as well since they went with a larger pulley on top. Same compound as the 15, different length.