Sorry to get a little off topic...
166 ,eh?....there's a local shop that offers to refund $ and return to stock if your not satisfied with that track.
Have you run this track before ?
Piece of mind
- Thread starter SSABMUD
- Start date
166 ,eh?....there's a local shop that offers to refund $ and return to stock if your not satisfied with that track.
Have you run this track before ?
No I hav not ran this track before, but there are a lot of guys going to this track in BC and swear by it. Guess we will see.
These Avids are 2.52 pitch you know? Will not work with any newer tracks.
Ahh crap. I need 2.86 pitch drivers.
S
snowmobiler
Well-known member
you get A+ for driveshaft macgyverism fix.
Ah yes, the money pit.
I have the stock drivers unless you are wanting extroverts. I can spin my track easily by hand now. Try this stock with the track tightened where it has to be!
Probably the best track Polaris ever made. 4k plus miles no problems tough as any track or more so. Have a local dealer selling them to Ski Doo and Cat guys
And boy does it work when the going gets deep..
Can't bring myself to ditch the new track quite yet but nice to know there is this route!!
That old Chevy is Badass !!
Thanks bud.
Yes, if you run any type of extrovert driver the rails need to be cut.
No it was the drivers i was mostly after. Ive had experiences with the stock ones. Ended up putting whal bros on my last pro rmk.
I put Wahl Bros in with this 2005 shaft. Much lighter than the Avids on this hex shaft. Don't think Wahl makes them yet for the 2013 shaft. Maybe they had a bad feeling about this shaft or something? Anyway a 2013 shaft with Avid drivers is quite heavy.
deleted (kind of silly we can't delete our own posts, unless I'm missing something.)
Last edited:
T
traveler
Active member
Did you use the clutch side bearing from your '13??
Yes I did seeing it had maybe one mile on it.
I have the Assault and they dont have the new driveshaft, so ill just buy some whal bros drivers for it.
Not really conviced that all 2013 pro drifeshafts are faulty, thats why i wanted to buy yours.
Just a heads up...
The Wahl drivers are for 2005-2010 IQ shafts only...
They use the same ones and "call them good" for the 2010-2013 Metric PRO Shafts.
The Metric drive shafts look similar but are about 1/16" smaller...
The Wahl bros drivers on the 2010-2013 PRO shaft will "fit" but will lack the good interference/compression for proper installation.
In SSABMUD's case... that is cool since he is using the SAE splined shaft of the 2005 IQ Chassis.
The 2005 shaft has the same spline dimensions as the 2006-2010 IQ's
"Present" is not an accurate statement
.
The Wahl drivers are for 2005-2010 IQ shafts only...
They use the same ones and "call them good" for the 2010-2013 Metric PRO Shafts.
The Metric drive shafts look similar but are about 1/16" smaller...
The Wahl bros drivers on the 2010-2013 PRO shaft will "fit" but will lack the good interference/compression for proper installation.
In SSABMUD's case... that is cool since he is using the SAE splined shaft of the 2005 IQ Chassis.
The 2005 shaft has the same spline dimensions as the 2006-2010 IQ's
"Present" is not an accurate statement
.