No power to gauges on MT1000

[ESCAPE TIME]

Any suggestions on why I have no power to my gauges and rear tail light, and maybe none to the head lights(they are deleted). Its an 07 so it has the chassis control also.I checked the 15amp fuse and its ok,sled seems to run fine,just my turbo is lubed by an electric pump and don't want to take out the turbo.Would a short do this,poor ground ??? I have a race pack on it,and it works fine,I'm a little puzzled by this, any help would be appreciated.

 

[DPalmerM10]

Check the fuse next to the ECU up front. Dave.

 

[DPalmerM10]

Sorry, I didn"t read the whole text. Dave.

 

[cpatts2000]

I had the same prob last year and my oil pump was also not working, ended up being the ground to the bulkhead just behind the air filter on a twisted kit.

 

[ESCAPE TIME]

Yeah, im thinking a groung or a short, this sled has been sitting for over a year, just put it back together resently.

 

[ESCAPE TIME]

The 15 amp fuse on the chassis control is blowing right away,as soon as I start sled. I have unplugged all plugs to bars and head & tail lights.Still have power to A/F,Attitude box and race pak, just not sure where else to look.Sled runs fine, just no oil(electric pump) to turbo,any ideas?? I haven't pulled the pan to check under motor,but I have unplugged three wire plug leading to chassis control from stater, put then no power from stater...no power any where?? I've also check grounds etc.

 

[Gobig510]

Taillight Wiring

Check the wiring to your tail lights, my wires were frayed, causing a short and blown 15amp fuse. There was no power to my speedo. I fixed the short, put in a new fuse and she was ready to go!