Method TRA

[rhino]

I need more RPMs... but when I take out fly weight it seams my belt starts to slip a bit. Can i take off weight and clicker down at the same time to eliminate the slip while increasing the RPMs?? i'm currently on #5 to get the higher revs but belt slips. No slip on #4 but revs are low. Just trying to get my mind around this. thx

 

[DaveB]

Well...no specifics given....but speaking in general terms, you could also change to a higher finish rate spring. IE: If you have a 160/320 spring, go to a 160/350.