Intake filter
- Thread starter Curt_T
- Start date
K
KTM365
Member
ya thats what we have done on many bikes
and thats what timbersled sells when they are running an sx kits (where the 3rd shock requires you to remove the air box)
we run the k & n crankcase filters with pre filter covers on our vent lines too
if its a efi bike u may have to relocate the airbox sensor and cover it with prefilter too depends on the application.
and thats what timbersled sells when they are running an sx kits (where the 3rd shock requires you to remove the air box)
we run the k & n crankcase filters with pre filter covers on our vent lines too
if its a efi bike u may have to relocate the airbox sensor and cover it with prefilter too depends on the application.
jetting
I've got a pod filter on my Kx 450 and getting it tunned has been tough I've got a 190 main and running in the 4th clip its running better know but not perfect but it has been slot of messing around trying to get it dialed
I've got a pod filter on my Kx 450 and getting it tunned has been tough I've got a 190 main and running in the 4th clip its running better know but not perfect but it has been slot of messing around trying to get it dialed
S
summit_man
Member
Filter
Call Les at Gary's Engine. Aberdeen SD.
605.225.6900
He will have the answer and materials you need. Smart guy. I'm running an intake on my 09 RMZ, that I picked up from him
Call Les at Gary's Engine. Aberdeen SD.
605.225.6900
He will have the answer and materials you need. Smart guy. I'm running an intake on my 09 RMZ, that I picked up from him
S
summit_man
Member
O2 sensor.
Airbox O2 sensor is mounted right in the silicone boot
Airbox O2 sensor is mounted right in the silicone boot
Here's the intake I made out of random stuff left over from other projects. Having a longer intake tube can help with flow consistency through the carb (one of many reasons tuning with a pod filter right on the carb can be challenging).
This was made out of a 45 degree 2.5" aluminum tube, a 30 degree silicone bend, stainless wire fence, a short section of stainless 3" exhaust tube, a 4"x6" intake prefilter, and a little time with some pliers. The joint between the prefilter and the silicone tube will be filled with silicone adhesive to make a nice seal.
This was made out of a 45 degree 2.5" aluminum tube, a 30 degree silicone bend, stainless wire fence, a short section of stainless 3" exhaust tube, a 4"x6" intake prefilter, and a little time with some pliers. The joint between the prefilter and the silicone tube will be filled with silicone adhesive to make a nice seal.
Last edited:
