Hole in airbox???? Normal???

[fuledya]

So I just got done installing a hole for fogging in the airbox, found a nice plug at Lowe's believe it or not. After removing the airbox I noticed a small hole in the bottom of the airbox, does'nt look like a clean hole. Is this supposed to be here? Maybe for draining any snow that could find its way in there? It is at the very lowest spot in the bottom. Hard to see from the picture, but its the best I could get. Anyone else notice this?

 

[snowmobiler]

drain

 

[fuledya]

drain

Thats what I was hoping.

 

[volcano buster]

Do you have a better picture of your plug install? How easy is it going to be to fog the motor with that location? I had the tank off mine a while back and wondered about inserting a plug on the tank side so you could squirt right into the throttle bodies. Your location would create a lot less work to get to though.

 

[xc6rider]

Do you have a better picture of your plug install? How easy is it going to be to fog the motor with that location? I had the tank off mine a while back and wondered about inserting a plug on the tank side so you could squirt right into the throttle bodies. Your location would create a lot less work to get to though.

Heres some pix of how i did mine. Check out this post...
http://www.snowestonline.com/forum/showpost.php?p=3075651&postcount=20

 

[assault11]

It's just a drain. The three I've taken apart had them also

 

[volcano buster]

Heres some pix of how i did mine. Check out this post...
http://www.snowestonline.com/forum/showpost.php?p=3075651&postcount=20

What exactly did you use for the plug? Picture is a bit fuzzy.

 

[fuledya]

Thats the same grommet and plug I used, only I used a black plug. Found them at Lowes.

 

[xc6rider]

Yea, i just used a 7/8" hole rubber grommet, and a plug for it. Sorry i dont have any more exact info. Found mine at a local Ace Hardware. Cost like 1.20 for both. But youll need a 7/8" hole saw. Gonna work very slick though!

Fuledya and i both got it installed in about the best place possible, atleast from how it looked when i dug into the project.