Gauges cutting out on 16' Axys

[HiMark Racing]

While riding, my gauges started to cut out (Flickering) kinda like when you see a bad ground on a trailer. I checked all connections (that I could see) and also the main ground. Now the gauges don't come on at all. The sled runs fine.

Anybody else have this happen?? Ideas??

 

[Murph]

Check the three relays.

2 are together on the bulkhead cross brace near the steering bushing.
1 is in the bag above the primary.

Common issue where water gets into relay or connection. Pull relays, clean any corrosion, blow out with air. Reinstall with dialectric grease, try and rotate the relays so water does not collect on them, and/or put them in a waterproof bag (i.e. small sandwich bag)

Also, if you have access to another Axys without the issue, swap the three relays and see if your problem goes away.

 

[HiMark Racing]

That may have been the fix..The one in the bag above the primary looked corroded, swapped it with one of the other 2 and we have power. Thanx!!

 

[Murph]

Good deal-- make sure you have clean/ functioning relays in all three positions. One runs power valves, one is oil pump.