Flywheel puller for 2005 Fusion 900???

[MNtravis]

I have the engine out and all apart but I cant get the dang flywheel to come loose!! I thought it would fall right off after breaking free the flywheel nut? Is there a specific flywheel puller tool for this machine? I have seen some on ebay before but didn't think they were needed for these Fusions. Any advice is mucho appreciated! I tried making a homemade puller with scrap steel I had laying around but it won't budge even with the impact wrench.

MNTravis

 

[Danbot]

I have always used a simple 3 bolt puller, but if it has been over-torqued they can be difficult. Good luck!

 

[sloan188]

SLP carries them...

http://www.startinglineproducts.com/catalog.cfm?pageID=detail&catalogID=3&catID=24&productID=217

http://www.startinglineproducts.com/catalog.cfm?pageID=detail&catalogID=3&catID=24&productID=1485