You'll need just one kit for a chaincase... 50ml.
.
.
FINALLY: COMPLETE, REASONABLY PRICED, "KIT" FOR LORDS ADHESIVE AND AN ALTERNATIVE
- Thread starter mountainhorse
- Start date
ttt for wellfed777
.
.
You are stoned plumb out of your gourd if you think, by any stretch of the imagination, that PL 400 sub-floor adhesive (designed and engineered for wood substrates) is suitable for bonding the aluminum on your sled together.
Additionally it is more expensive than the correct stuff.
You have partaken of way too much of that good BC bud my friend.
If Lords is too hard to source in your area; your Napa or body shop supplier can supply you with the Fusor line of Lords products marketed by Napa under their Martin Semore line.
Awesome info MH. I am doing a tunnel swap and ride side lower brace mount[ next to the motor], How much material do you suggest?
Amounts
I'm doing the chaincase bulkhead supports to the tunnel, the rear portion of the close off under the engine, the whole tunnel is off as well as the sides of the tunnel.
Should I adhesive the tunnel sides to the heat exchangers, the running boards to the tunnel? as well as the above mentioned ones?
How much do you think I would need?
I believe I sent you a pm "Mh" but it doesn't show in my sent messages box. Sorry for bringing up a old thread
I'm doing the chaincase bulkhead supports to the tunnel, the rear portion of the close off under the engine, the whole tunnel is off as well as the sides of the tunnel.
Should I adhesive the tunnel sides to the heat exchangers, the running boards to the tunnel? as well as the above mentioned ones?
How much do you think I would need?
I believe I sent you a pm "Mh" but it doesn't show in my sent messages box. Sorry for bringing up a old thread
Thread copied from ProRide section... applies to adhesive used on the AXYS as well.
.
.
Similar threads
