F
Flying Dutchman
Well-known member
OK, I have a few questions when going to Revy.
I have an ATAAC on my RMK and it's set for 2950 feet for a base elevation since I have never gone below that elevation.
The town of Revy is only 1600 ft.
I am assuming the trails lead straight up into higher elevation, so do I need to worry about my jetting?
I know I can remove the blue hose to reset the base altitude but that will also mess with my jetting....... plus all the controls are inside the box and i do not really want to take that apart.......PITA
Or, can I ride nicely for the first bit until getting past 3000 ft.
Or are all the parking lots, etc., higher than 1600 and only the town itself is low.?
I know the ATAAC will work fine once up there, just concerned on the base elevation.
So if anyone can give me some elevation numbers, maybe I'm worrying about nothing.
I have an ATAAC on my RMK and it's set for 2950 feet for a base elevation since I have never gone below that elevation.
The town of Revy is only 1600 ft.
I am assuming the trails lead straight up into higher elevation, so do I need to worry about my jetting?
I know I can remove the blue hose to reset the base altitude but that will also mess with my jetting....... plus all the controls are inside the box and i do not really want to take that apart.......PITA
Or, can I ride nicely for the first bit until getting past 3000 ft.
Or are all the parking lots, etc., higher than 1600 and only the town itself is low.?
I know the ATAAC will work fine once up there, just concerned on the base elevation.
So if anyone can give me some elevation numbers, maybe I'm worrying about nothing.
