Another suspension mounting question.

[N2OTOGO]

I have searched and haven't found exactly what I'm looking for.
I need the suspension mounting locations from a 2001 rmk 144.
I need location from driveshaft to front suspension location hole. Also from top of tunnel to front mount. As well as from front hole to rear mount hole along with from top of tunnel to rear mount.
I looked at the jbshock page but not sure if any of that applies to the 144 skid. Also do you adjust mounting holes accordingly for a drop and roll?
Thanks,
Mark

 

[minibob]

Hello Mark , I have a 2001 RMK with the 144 extra light skid , I will measure it on the weekend and post them .

 

[N2OTOGO]

Thanks I really appreciate it!!

 

[minibob]

Good morning Mark ,
I am not able to attach the hand drawing .
I will try and explain .
I used a carpenter square against the inside of tunnel against the corner strip .
All measurement c/c .


From the front , hex to first mounting hole 10 3/4" .
-first mounting hole to second mounting hole 28 1/4"
-second mounting hole to third mounting hole 2 1/4"


From inside of tunnel , hex to tunnel 6"
-first mounting hole 5 1/8"
-second mounting hole 6 1/2"
-third mounting hole 7 1/8"


If this does not work for you pm Me and I could email to you .

 

[N2OTOGO]

That's perfect!!
Thanks I truly do appreciate you taking the time to do that!!
?????