2018 YZ450F mods needed?

[800tundra]

Sorry it’s sideways

•Added Garmin Montana [emoji106].
•Seat concepts which I feel is not as near as comfortable as the fisher that I have rode on a different bike [emoji107], as my tailbone was sore after 2 days riding ,and using padded bike shorts. But Stock seat is basically a 2 by 4 wrapped in razor wire
•Trail Tech temp plumbed into thermostat which registers much lower than the factory temp (Monitered from bikes Bluetooth App)[emoji848]. So jury still out till i figure what proper operating temp will be.
•CR racing Intake which seems to work fine[emoji106]but is brutally loud [emoji107]
•P3 Guards [emoji106] (took a little minor mod to install)
•Forks done at RMR[emoji106]
•Cyclops light [emoji106]
•Modified existing Nytro tarp for Hauling on the sleddeck. [emoji106]
•Raze (tall)Pastrana bars with powermadd riser. Heated bars work great.[emoji106].
•Pst engine Blanket[emoji106]
With the tall bars AND riser had to do alot of cable re-routing.
•Pelican case with my Stihl saw[emoji106]





Sent from my iPhone using Tapatalk

 

[KtmKen]

Also unplugged\removed launch control. Anybody foresee this causing issues?

How did that work out for you? Any issues?

I was thinking of doing the same and just using heat shrink tubing to seal of the remaining connector end.

 

[800tundra]

No issues.

 

[KtmKen]

Do you mind telling what ended up settling on for a tune?

I think I ran -3/+3 pretty much all of last season without any issues, but I was wondering if there are any stepped tunes people have tried or settled on as an alternative.