2013 Tial turbo!!

[SnoPro88]

Just thought i would post some pics of my little build. Boondocker Tial GTX 2863 turbo. Have not had it out yet, Who else has this kit and what do you think. Would love to see some vids of this kit.

 

[knifedge]

--I am interested to see how the 2863GTX runs with the intercooler

 

[RACINSTATION]

Sled looks awesome! Clean install.

 

[SnoPro88]

Thanks. I'll try to post some vids as soon as i have time.

 

[kcdavidak]

yep got the cousin sled just like it . cut a little off by 3'' header and wrap it. no problems. bend up a little heat shield for under the exhaust box the forward corner of it get a little hot. trim side panel by header back about an inch. got to put inner air box on then charge tube to throttle bodies. be sure to lift intercooler up and back when getting hood on all the way.put hood side panels on after joining inner air box to center hood . vent both front and back off panels (modrods) upper panel not necessary at this time waiting to see, a mini air saw was a big help with this project. and pay attention to where you drill that 5,3/4/ hole for fan !! kinda oops that one but it's all good. built two of these ,they are so cool. you will be so glad when you ride it not like previous gt kits .

 

[kcdavidak]

also found that it was easier to take the skid plate off, to get pto side water line out of holder under engine and reroute it to turbo,or you won't have enough hose .

 

[kcdavidak]

if you have any questions, just send me a pm

 

[gus bohne]

damn pretty !!!! well done

 

[SnoPro88]

yep got the cousin sled just like it . cut a little off by 3'' header and wrap it. no problems. bend up a little heat shield for under the exhaust box the forward corner of it get a little hot. trim side panel by header back about an inch. got to put inner air box on then charge tube to throttle bodies. be sure to lift intercooler up and back when getting hood on all the way.put hood side panels on after joining inner air box to center hood . vent both front and back off panels (modrods) upper panel not necessary at this time waiting to see, a mini air saw was a big help with this project. and pay attention to where you drill that 5,3/4/ hole for fan !! kinda oops that one but it's all good. built two of these ,they are so cool. you will be so glad when you ride it not like previous gt kits .

yeah my hole for the fan was about an inch to far forward but at least it gets covered. i had just enough hose for the coolant line to reach i didnt have to take it out of the holder.

 

[summit-x]

is there any way you guys could explain to me how to wire that damn air to fuel guage? also where should i weld in the bung? i dont have the tial kit just the 13 standard 2860

 

[kcdavidak]

the easiest place to get power is the 12 vlt plug just tap into it underneath. haven't seen the standard kit in person yet,kinda standard rule of thumb is put probe after turbo. on my 2010 2860 welded o2 bung just before exhaust donut bellow . took exhaust plate off turbo to weld.you can also use the power from back up beeper,12 vlt as well

 

[summit-x]

okay thanks man

 

[summit-x]

12v dc correct?

 

[kcdavidak]

innovate gauge is 12 vlt dc,

 

[Vi-PEC Powersports]

looking awsome, well done.