2008 M8 Boondocker Controller Install Help

[cat rider]

So I'm needing a little help with my boondocker controller. When connected the sled won't start, but when I switched it back to normal (before the contoller was installed) it runs fine. I have grounded it to the chassis. Do the wires need to be changed around in the factory injector connectors? I know you had to do this with the pure logic controllers.

Thanks

 

[hatchers]

could be a needle in a hay stack troubleshooting event??

if the wiring is good, the older box has a idle setting, plug up a 9 volt battery to the box only and see what the idle number is, do not let this battery turn on the fuel pump (just un plug the fuel pump as i have no clue how you wired it, and i do know the older boondocker wiring had just about every thing on the same 12VDC cicuit)

its best you post pics and explain more about what you are doing, whos kit, yada yada...

 

[Pilsner]

You probably have the injector wires backwards, double check with the instructions, flip the wires around, to rule that out.

 

[73GOLIATH]

hi
on the black connector from boondocker there is a yellow dot on it the red wire needs to be in that side on both connectors

 

[cat rider]

hi
on the black connector from boondocker there is a yellow dot on it the red wire needs to be in that side on both connectors

So that is what the directions are trying to say. They're a little confusing.

Thanks for the help guys! Hopefully I'll get it figured out. I've never run the boondocker controller before, only the pure logic.