06 800 Rebuild

[Tackbtch]

Soooo Ive got the cases split, going to replace the crank seals and repack bearings. Sled is a 06 800 Rev X , the only other crank Ive done was an 02 800. My question is on the 06 witch bearings take grease on the 02 it was the pto side on the 06 it appears that the mag side bearing takes grease Also do the two bearings in the middle take grease or oil???I know it should be obvious ... just haveing a bad day and would like some insight from peeps who know. Thanks Dino

 

[summit800]

2 outer on clutch side and outer on mag side

 

[Tackbtch]

2 outer on clutch side and outer on mag side

It appears that the two on the PTO are well lubed with oil and no sign of ever havering grease...thats whats throwing me a curve ball Dino

 

[Tackbtch]

Anybody?

 

[revrider]

Like summit800 said the pto and the mag side bearings take the isoflex greese. The middle ones are oiled with the injection oil. When putting it back together you need to take the oil pump off and fill the cavity with injection oil. Then when hooking up the oil line there is a 8mm (or 10mm I cant remember for sure) on the oil pump the needs to be loosened or removed to pruge the oil line of air. Do a search on the Isoflex and it can be bought at less than 1/2 the price of Skidoo. You can also buy a complete gasket set from Seedoo clinic for around $100.