My "adventure" with the 900 RMK
Hello guys, so a short intro into what my plans are for this thread.
I have been a proud owner of my 2006 900 rmk 151 for about 4 seasons.
shortly after purchasing I found this forum dedicated to the 900 rmk's.
I have found tons of info on here, in fact every...
2012 Polaris 600 RMK 155"
This 600 is a very nice, light snowmobile in excellent condition. It is mostly stock and has been owned by beginners so it has never been abused. Well maintained with under 1100 miles. Starts easy and runs strong. Nice and light so it stays on top of the snow better...
2014 PRO RMK 800 - 640 MILES, 4 YEARS OF WARRANTY LEFT ON SLED
-POWDER COATED RAILS, SPINDLES
-CARLS CLUTCHING
-HEADLIGHT DELETE, I HAVE ORIGINAL HEADLIGHT AND WIND SHIELD
AWESOME GREAT RUNNING SLED!!
LOCATED IN MCCALL, IDAHO!!
$8200 CALL/TEXT BRANDON @2083152380
2013 Pro RMK 800 155' with a spotless Boondocker pump gas turbo. This sled is well maintained and the turbo only has three rides since install. All updates are current on the sled which is stored in a heated shop. Below are specifics and parts
Boondocker Turbo(pump gas)
GTX2860 On-Demand...
2013 PRO RMK
Excellent conditions, never crashed or damaged.
Completely new professionally rebuilt engine under warranty with approximately 150 miles on it
Side panel vents
Stirrup vents
Skid Plate
F&I Belt Tensioner
F&I Motor Mount
Holtz Rear Bumper
Engine Block Off Plate
Under Seat Bag
$7800...
This sled was stock for the first 200 miles. I bought it with 500 miles on it and it currently has 578 miles. I only rode this fire breathing dragon 3 times due to my previous job away from home. This beast didn't leave my garage last winter due to low snow.
Additional Accessories/Info...
This snowmobile has been stored indoors and is in great condition. The Timbersled Rear Suspension has less than half of a season of use.
Timbersled Rear Suspension with a Fox Float Evol and a Fox Float 2 shock
Avid Anti-Ratchet Drivers
Ice Age Johnny Law Idler Wheels
Anti-Stab Wheel Kit
Skinz...
2014 RMK 800 155" CUSTOM WRAP, ETC. SE MI ***********************************
2014 POLARIS RMK 800 155"
- AMAZING MACHINE.
- 2.4" LUG
- NO E START
- 3400 MILES
- ARCTIC FX CUSTOME WRAP
- CARBON FIBER CAN
- POLARIS SKID PLATE
- TETHER KILL SWITCH
$8000 CALLS OR TEXT ONLY
SE MICHIGAN...
Im selling my polaris 700 Gen 2. Its been stretched to a 151 and has about 500 miles on a new engine. It also has
-Slp Twin pipes
-Team tss-98 secondary clutch
-Slp Boost Bottle
-2009 Dragon Skis
-Stronger Radius Rods
-Fly handlebars
- Risers
-New brake setup
-New throttle block and throttle...
I have 4 Polaris edge chassis sleds for sale. I have a 2002 snow check red 156, with the following extras. It has a Timbersled light weight front end, Fox floats on front, twin pipes, SLP air horn kit, lefty throttle and Boss high rise seat, Asking $2300 obo 2003 Polaris Vertical Escape 159...
I have Unit 6 cans for sale. They are fully polished stainless steel with carbon fiber. They are excellent quality and weigh in at 5 pounds. Not too loud at 89db. Available for XM, RMK, M8000, M1100 and also for UTV's. These are a new product, and so we are selling them cheap to get the...
I'm currently working on putting a 136 xtra lite skid in my MM. I need the height measurement from the top of the tunnel to the center of the drive axle from a sled with this suspension. I have the other measurements from JB shocks (http://www.jbshocks.com/x10mount136.jpg). But I need to relate...
Ive got a 2006 RMK 900. Runs great, excellent power, all in all good sled. Heres the problem. Check engine light bliks five (5) times. It always blinks. on startup, idle, and running. I have replaced the EGT sensor, cleaned associated connections. The Code Page says it will illuminate if...
Hello I have a 99 rmk 700 I am new to upgrading sleds and would like some input on the slp single pipe set up. I am buying a full slp single pipe set up part#09-719s and after reading other posts I am a little confused on whether I can just slap it on and ride or if I need to make modifications...
I am having trouble with my Sled. Once the engine gets up to temp the instrument panel with cut out completely with the sled dying shortly after. Sometimes in will start up right back up and run without the screen and sometimes I have to wait a while before it will start. It has had a new ECU...