october 2015 ask the experts

Amsnow

AmSnow.com is now SnoWest.com

Backfire problems
Q: My RMK 600 keeps backfiring on takeoff. First I thought it was because the throttle cable was bad. I replaced it as well as the plugs, had it re-jetted for higher elevation. I rode it for two days and it screamed, but after sitting for two weeks, it started acting up again. It’s been in the shop twice, and $300 later, it still has the same issue. – polarisdavermk600

A: It sounds like it is a carb model where you re-jetted it for elevation. Usually when we see a sled backfire it is because it has raw fuel in the pipe or silencer. This can happen when the sled is run hard and shut off without allowing the engine to come down to an idle. When that happens, the spark is shut off, but the engine continues to pump its air/fuel mixture through it, causing the air/fuel mixture to end up in the pipe and silencer. When the engine is fired up again, the unburned air/fuel mixture in the pipe ignites and backfires.

If the sled backfires when you take off (after it’s been running), it is most likely due to a misadjusted throttle cable/lever. The throttle override safety switches cut the spark for a second or less, pushing the unburned air/fuel mixture into the pipe and silencer. When the spark returns, the fuel ignites and backfires. A properly adjusted throttle lever should only be able to move away from the throttle block approximately the width of a credit card prior to pulling on the slides of the carbs. Too much slack in the cable will cause the throttle override safety switches to cut spark. I’ve also seen a dual throttle cause this problem when the throttle lever pivot point is tightened too tight, not allowing the lever to pivot smoothly and engage the switch properly. A faulty throttle override switch could also be the cause.

If the engine is allowed to come to an idle before being shut off, and it backfires when it is restarted, then I’d have to say the idle air/fuel mixture is too rich on fuel. The unburned fuel gets pushed into the pipe and silencer, where it ignites the next time it is started. Other common things that can cause this are a choke cable that is out of adjustment, a choke plunger that is stuck or leaking, a fuel pump diaphragm that is leaking slightly, a needle and seat within the carb that is leaking or a misadjusted float level. I’ve also seen it happen with a bad spark plug cap or wire that gives intermittent spark. Usually these items show up as more than just a backfire, though. They typically will result in a rich condition or misfire. If the sled has a low idle, or difficulty idling, then one or more of these items may be the culprit. – Jerry Mathews, Starting Line Products


Where to set WOT
Q: When setting WOT on your carbs, do you set the slide flush with the roof of the carb on the intake side (flush with cutaway) or flush from the engine side of the carb? Basically, how far should a carb slide be up for it to be at the optimum WOT position? – FrankieJames7

A: You need to set the slide flush with the backside, otherwise the bore will be slightly closed and the millimeter opening will not be correct. – Jason Houle, Straightline Performance


GOT A TECH QUESTION? Post it on the AmSnow forums! We have the connections and the know-how to answer your tough questions. No question is too small, so whether you are a novice or a veteran rider needing help, our experts are ready!
  • Like what you read?

    Want to know when we have important news, updates or interviews?

  • Join our newsletter today!

    Sign Up

You Might Also Be Interested In...

Share

Send to your friends!

Welcome to Snowest!

Have a discount code on us.

Discount Code: