S
my 07 m6 started flashing the engine code that the pipe sensor needs replacing but the sled is running fine, what should I do? could it be dirty or anything like that?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
On the 07 and 08 M sleds Arctic Cat bent the wire over and zip tied it.
I lost the sensor on my 07 M1000 and the dealer told me to leave the zip tie off because the vibration stresses the wire until it gives up.
I have used/broken 3 of this sensors.And are doing a test now for what restors that works best.
Put on a new sensor/resistor and you will be amaced the diffrence,,Mine broke a 100 miles ago on my 08 M8.... still goes good, and since I started using mid grade as opposed to premium, even better.
I still get code 17 every now and again, and the wrench regarding the CCU?
No difference in performance.
Have tried 450-490 ohm and they all work good, have over two years with them in a 07 M1000T and a M800T.
Kevin