Zbroz axys spindles on pro rmk

[Clarke673]

Assembling a new pro assault build. Planning on running axys geometry as much as possible. Looking at ordering a set of Zbroz spindles. Anyone else running these or other axys spindles on a pro?

 

[ullose272]

pro spindles have a cast in spacer on the top of the spindle, axys has a spacer built into the ball joint. that should really be the only difference other than it being taller, which would open a new can of worms. but sounds like you know that

 

[ak]

I run pro spindels on my axys I think it handles better on a side hill. So they will interchange.

 

[Clarke673]

seen a couple broken spindles on the new axys's rolling out of cooke. Granted, something has to give and personally thats not a bad spot. I have seen a few broken pro/dragon ect spindles but only under extreme situations.

Zbroz vs Skins?

 

[MrIQR]

There was a thread on this, they did axys spindles and dropped the skid 3/4" to match axys geometry as much as possible..


Verdict was it was not an improvement, I'll see if I can find it..

found a couple threads but not the one I had looked at before..

You thinking drop and roll also?

http://www.snowest.com/forum/showthread.php?p=3890229
http://www.snowest.com/forum/showthread.php?p=3949030

 

[Clarke673]

I have an ice age drop and roll chained case, alternative impact assault width arms, ezryde, 7tooth avoids, ordering spindles today!

 

[icr]

Why 7t drivers and a drop and roll?