XP Summit owners, need some info please.

[Teth-Air]

I'm working on a revised spindle spacer for the XP's and would really appreciate it if some guys would measure the center to center from tie rod-end bolt to tie-rod end bolt. The stock measurement is what I am looking for before anyone has adjusted or smashed up their front ends. I expect both sides would be the same but it will be interesting to see how close everybody's measurements are as this will tell us how good the BRP Engineering is.

Again I am looking for the the measurement between the center points of the tie-rods.

ps, for clarification, in the parts list, BRP is calling the tie-rod ends, ball joints.

thanks in advance.

Chris

 

[Teth-Air]

Anybody?

 

[snowmobiler]

my adjustable rod is 19 1/8

 

[Teth-Air]

Thanks, I suppose both side were axactly the same as I believe the steering post is exact center?

 

[YellowMissile]

19 1/8" Here too, same both sides. Going longer with the spacers Chris? I have been rolling an idea around in my head for a spacer for the front skid shock. Do you figure it was the shock bottoming or a change in geometry (a bind in the linkage) that caused your shock mounts to bend and fail?

Justin