Sled ran fine all day then on the way back to trailer sled went to one cylinder,gauges were flickering, lights going off and on, gauges would go out and the "service" would light up. Then BAM back on full engine power and gauges all good. So there is no doubt its electrical but could be a regulator or a stator...or a shorted wire or a coil pack. I was going to start with regulator but in the grand scheme of things after talking to the dealer he said...."bring it in and we will scan it"
I am thinking there is no CEL on so would there be any stored trouble codes? Would there be? It would be nice cause sled wont act up again right now so it is hard to duplicate and pin point. DO you guys think there will be any DTC's??
I am thinking there is no CEL on so would there be any stored trouble codes? Would there be? It would be nice cause sled wont act up again right now so it is hard to duplicate and pin point. DO you guys think there will be any DTC's??