whos using a billet throttle block on their Nytro

[Nikolai]

Wondering who is using a billet throttle block on their Nytro and what make/brand/model it is.

 

[HYFLYR]

I think this is the one im gonna use,

http://crracingcanada.com/osc/product_info.php?cPath=43_48&products_id=151
This bar setup is clean, i like it. Stole this pic from the general section

Nice, simple, and clean!

 

[Hrt Offroad]

I'm using the CR Racing Billet throttle block. It works great

 

[Nikolai]

Looks good...order two

 

[Hrt Offroad]

I think this is the one im gonna use,

http://crracingcanada.com/osc/product_info.php?cPath=43_48&products_id=151
This bar setup is clean, i like it. Stole this pic from the general section

Nice, simple, and clean!

Looks similar to my set up...I have since ditched the Yammi brake lever/master cylinder assembly and e-brake for a Doo lever/master cylinder assembly...and mounted headlight and heat controls on my riser block. It's real clean now!!

 

[Nikolai]

That's exactly what I want to do with my bars. Except I just ground the Yamaha brake down so it's clean and will powder coat it. RSI has a nice handwarmer switch here http://www.rsiracing.com/product_info.php?cPath=0_30&products_id=209. They also have a nice block for $40 http://www.rsiracing.com/product_info.php?cPath=0_30&products_id=214. I'd like to run two of the little switches and use one for the hand warmers and one for the headlight.

 

[Hrt Offroad]

The switches look good!! I think I would opt to go with the CR throttle block - it utilizes the factory Yamaha throttle lever and works perfectly. Just my .02