Looking for place to power my digitron on my '07 M8. My M7 had auxillary plug but I didn't see one below handlebar riser on my M8. Any suggestions??
Where is auxillary Power on '07 M8--Different set up than my M7
- Thread starter WaBackcountry
- Start date
The auxiliary plug is plugged into a dead-end cover for protection from the elements. It should be sticking out behind the left side of the aluminum steering brace hoop.
If you don't see it there, remove the three Torx screws from the aluminum close-out panel and you should be able to find it.
If you don't see it there, remove the three Torx screws from the aluminum close-out panel and you should be able to find it.
Mine only measured 2.7 volts from that plug on a 07 m1000
and the yellow wire from the stator ( in velcro wrap) measured the same
So I tapped into the fuel pump hot lead and get 16.7 volts....is this a good source..some say we need rectrified power, and to come off the chassis control module.....
My Digatron only blinks and is giving me fits
and the yellow wire from the stator ( in velcro wrap) measured the same
So I tapped into the fuel pump hot lead and get 16.7 volts....is this a good source..some say we need rectrified power, and to come off the chassis control module.....
My Digatron only blinks and is giving me fits
'07+ sleds have DC systems and the plug at the steering post on my '08 puts out a nice clean steady 14 VDC at idle.
The auxiliary plug has one black wire and a second black wire w/ red stripe (DC).
Just went and took a photo worth a thousand words...
Can I use this to power to run my fuel air gauge from D and D?
Boondocker told me I would have to put a battery on my 05 M7.
Am I understanding correctly that the 07and later are DC and my 05 is AC?
Boondocker told me I would have to put a battery on my 05 M7.
Am I understanding correctly that the 07and later are DC and my 05 is AC?
Can I hook GPS to this plug shown above? Been told yes and no, 2009 Xfire
