What all goes into changing a secondary helix?

[Dmill]

looking at replacing my helix and have no idea what im doing here.. im guessing i need to pull my secondary, but ive never seen the back side.. is that where i will see the nine torx bolts? i figured it looks like a pretyy easy job just wanted to know what all it entails or if anyone has a guide.. thanx

 

[Shift_Fast]

You need some sort of spring compressor and some heat on those torx bolts for sure.

 

[dfinn]

You need some sort of spring compressor and some heat on those torx bolts for sure.

spring compressor needed even with 2 people?

 

[LS1NOVA]

Just use a long bolt or allthread and some washers. Make sure to loctite the little screws back in.

 

[CO_MapMaker]

spend the $$ on the compressor, they are less than $100. Heat is also the key.

I usually have a bunch of new torx bolts on hand also as the old ones can get messed up, they come with loctite on the the threads.

Not sure were the thumbs down on my reply came from??????

 

[trax]

i just used a piece of ready rod and stuck through the clutch and put some washers on both sides. took out the torx bolts on the back side and then started to loose the nut on the ready rod and the clutch starts to open up. its as easy as that.