Just curious if plug and play wiring is in the works for external sensors, afr, recording, etc. Would be nice to have a setup like the power commander plugs, pre wired and ready to go.
VIPEC
- Thread starter gopher-it!
- Start date
The only way i can see them doing this is to have a plug in connecter with 3 jumpover connector prewired 2-connectors for the stock wireing connectors and the three connector would come pre wired with outlet lead wires for the AFR , map sensor , etc ., this would not nmake a neat looking job and would add cost to the product .
But with having spare pin points alreading in the stock ECU wire connectors , it make a much neater job just adding the pins to the stock spare connector slots .
Last edited:
I agree, I would much rather add a pin, takes 5 mins and have a clean wire harness then have all these different connects going everywhere.
