Ulmer Nytro Engine Code 35????

[quadtrac]

Took my 08 nytro out today and it was running great at about 6lbs boost. Then I let it idle for a few minutes and all the sudden it sounded like it was missing on one cylinder, and then I seen it was flashing engine code 35. I was running 50/50 avgas in it at the time. I tried to drive it around to see if it would clean out and once in awhile it would run fine. But now it I cant get it to run any better. Any Ideas? Thanks Guys!

 

[SRXSRULE]

Thats the code for #3 igntion coil. May have a bad coil or a loose connection. good luck. Eric

 

[frees-tyler]

Check to make sure the wiring harness just behind the primary clutch is not rubbing. If you remove your clutch you can see it quite easily...the harness does a 90* turn right near the front motor mount and will wear through. worth a look