Supreme Tool motor mounts and bumper - anyone try these

[Evolution Powersports]

I have been looking for a torque stop and motor mount solution for my M1000 and came across Supreme Tool's solution.http://supremetoolinc.com/cart/bolt-ons-c-14.html?zenid=0c45d57047e68d760ed0c8e539da03d8

They have both harder motor mounts and a hdpe part to replace the rubber bumper between the engine mount and gearbox. Both look like fairly elegant ways to keep the engine from moving under power. I have ordered the hdpe part to replace the rubber bumper for now.

Has anyone else used these parts?

 

[spoon]

I put in the Cat Sno Pro motor mounts in all 3 on the motor plate and it worked great until the top back mount ear on bulkhead cracked and broke off my bulkhead. Now I only install the hard mount on front mount only but the hard plastic torque bumper looks like a great idea. I have just made a bolt on kit for the front torque stop for the M1000 that is a no drill install using existing hole in bulkhead and provides a flat surface for M7 torque stop to push on motor case. Current torque stop install requires drilling a hole lower than existing hole (not easy with motor and oil tank in place) and it pushes on v-shaped section in front of recoil (mimimal surface area on rubber face). Have design planned and tested, just need to get to a CNC machine. Small 1/4 thick aluminum plate bolts to existing hole in engine face and lines up with existing hole in bulkhead making for easier install and works much better as well. Do this with solid mount in front of clutch and it will keep an M1200T in place under full boost while putting minimal stress on bulkhead. Will be putting a kit together and will be in 50-100$ range depending on year of sled. 09-10 M1000 do not need front motor mount on engine plate as they already have the solid one.

 

[Evolution Powersports]

That sounds like just the ticket. Let me know when you have this ready for sale.

 

[minet]

ditto , update us when you have some to sell pls

 

[spoon]

Got the proto to CNC shop yesterday and next week may have some to ship, now the M7 torque stops are on backorder. Have a few to make kits for now. May have to get some Polaris stops as they work as well.

 

[Evolution Powersports]

Sounds good spoon. PM me with the cost and ordering info when you have them ready.