SLP Saddle Brackets for powder pros

[aebsledder]

Anybody have this set up on an 03 edge chassis? I am installing some for a friend and I noticed that the rubber "rocker" the spindle sits on doesn't have a keeper on either side of it like the IQ chassis has. Just wanted to double check and make sure this is correct. Seems like it should work.

 

[tahoermk]

yup

My gen 2 saddles don't either, the rubber just floats in there, held by the pressure from the spindle. Put em on, they're fine.

 

[ullose272]

same here, they wont go anywhere

 

[this1ultraflyz]

Ok do the Gen 2's work on the the edge well. I'm thinking it owuld be like the wide tires I had on the Trans Am when I was 18. As soon as it snow the front tires pushed snow and I would get stuck on the flat or slight down hill. Buddy has then on his Nitro (Stock otherwise) And seen him get stuck a few times just trying to get going in not bad snow conditions. Can you even stop on level ground with them?

 

[aebsledder]

Thanks