Anyone mount a ski doo SCIII in a mountain max? I want to find out the distance from axle to suspension mounts and measurements from CtC for the front & rear holes.
Ski doo SC10-III 151 in a mountian max
- Thread starter Wrenchmaster
- Start date
If I'm not mistaken, you need to get the measurements from the donor sled.
Got the measurements, front mount 9.25" back from drive axle ctc. and 6" down from top of tunnel, 32" to rear mount 7" down.
Pics of the install? 
Awesome I needed those measurements as well:
http://www.dootalk.com/forums/topic/511717-97-mach-1-700-long-track-build/page__st__30#entry3972182
http://www.dootalk.com/forums/topic/511717-97-mach-1-700-long-track-build/page__st__30#entry3972182
Sorry, haven't checked this thread for a bit, yes I can post pics. I think I'll be doing a build thread soon since I've done a ton of work on this thing so far this year. When I get the pics up, I'll post a link. Here's a couple, not the best of the install, I swapped over to an Ekholm tunnel at the same time as installing the skid and a 159" track.
You say that is an ELkholm tunnel? Has that tunnel been modified? I have not seen one with foot rails like that. looks great.
Yes, it's an Elkholm with a drop & roll, but I've modified it quite a bit. Built the boards out of grip edge from an Apex tunnel and stretched it 12" or so to accommodate up to a 162" track. It's got a Polaris 159" because I kept the 2.52" pitch drivers. Here's a pic of the board mod in progress. I painted it too, since it was faded yellow when I got it. Gross! lol
Modified is an under statement. I like it. Great job.
