push arm??

[MacDawg productions]

Hey guys, is it called the push arm that threads into the pto side of the motor support bracket. It's like a stop. Mine's toast, so I need to replace it. Thanks.

 

[jafraune]

I had to replace mine....its like 10 bucks from the dealer....i just called it a torque stop

 

[mountainhorse]

You need to make sure that it is adjusted with the proper clearance... .030" to the block or it will be toast again. Tight stops induce vibration in the chassis.

Many times, if the torque stop is toast... this is a symptom of broken front motor mounts... BUT... here's the sukky part.... you cant tell if they are shot with the motor in the sled. About 3/4's of the 2005 900 RMK's I've pulled the motor on had broken front mounts.

Ruied torqe stops are an clue you might have broken front mounts.

 

[MacDawg productions]

Thanks guys, my motor is at Indy dans right now getting a tm3. The front mounts are toast, but i've got some comp fusions on the way. So I will call the dealer up and tell them it's a torque stop mounted on the support bracket that I need. Cool.

 

[jafraune]

Macdawg.....part # 3021354

about 10 bucks.....

 

[MacDawg productions]

Deadly, thanks jafraune!!

 

[jafraune]

no problem.....its funny because i had my sled over at indydans place earlier this year and he found that my torque stop was completely mulched....

 

[2poor]

Dont run a stock torque stop they ar a soft rubber get one off of a edge chassie they are much harder.