Pro Rmk - Rear suspension mounting

[2blade]

I have a set of custom length Walker Evans in the front suspension that are 17-3/4" long. Does anyone know if you can use the skidframe lower front arm mounting location with Pro-Rmk rails?

 

[2blade]

ttt

 

[mountainhorse]

I wouldn't... It is ok to go the other way... Assault-to-RMK position.

But the RMK's rails are not turned up in the front enough... which is why Polaris has two different sets of rails on the same suspension arms in the same length track.

The Shocks are a tad long...Were they from another sled??

 

[John 970]

Sorry to jump this post, but I did.

Thank you 2blade, Thank you MH.

I don't know what the 17-3/4 was off of, so I maybe asking the same question.

I wouldn't... It is ok to go the other way... Assault-to-RMK position.

But the RMK's rails are not turned up in the front enough... which is why Polaris has two different sets of rails on the same suspension arms in the same length track.

The Shocks are a tad long...Were they from another sled??

MH I need your advice, or anyone else and this seems to be a good chance.

I scored a set of low mile Assualt RMk track shocks I would like to put on to my PRO RMK. I was hoping to put the Pro spring onto the rear Assualt shock as I weigh 230+ all geared up.

Will this work?

p.s. I think I already killed the rear factory shock. When I push down on the sled, it just kinda stays there. Lots of sag.

Thanks.

 

[2blade]

The shocks were made up at walker evans. They are shortened assault shocks.