Ported 975

[Meatman]

I think there is enough interest to part out my power plant so hear goes nothing. This made 220hp @ 8600 RPM I still have the complete set up but as soon as one thing sells the deal is gone. For the complete motor including all electrical, SLP twins and 54mm CPC carbs, I am asking 2500. I have the complete specs listed elsewhere, if you are curious shoot me a PM and I can send you back a list. Meanwhile here is what is included in the top end.

Top End

2 Cylinders bored to accept stock M1000 pistons Ported by "Turbotator"
1 RKT Monohead
2 High Comp Domes
STM Power valves
Spacers to clear M1000 piston skirts

Will ship anywhere in the lower 48 for $1500 The top end is ready for pistons, slap it on and take off.

PM for more info

Thanks
Brandon

 

[firecat99]

So you have a complete motor and a complete top end? Did you get that hp numbers on race gas or pump?

 

[Meatman]

the top end is part of the complete motor. I got the whole thing priced at 2500. However if say the carbs sell of the pipes sell then the 2500 is off the table. I have the complete set up listed as well. I had no interest in parting it out earlier but I have had numerous inquiries about specific parts.

Numbers are at 800' using 110oct on a crank dyno. I ride between 9k and 11k and run either 100LL or mix 110/92.

Thanks
Brandon