PAR running board and tunnel support install

[snow gumby]

Hello,

Didn't find much info about these boards on the forums. Putting a set on my 2012 Pro 800 155. Brad said there isn't any instructions with the boards. I have some past sheet metal experiance and going with regular rivots not pop. Just got off from working a 12 hour midnight shift and was brain dead when he called. So I can't remember everything he said.
I've seen the boards in person last summer on a very clean mod sled. But I didn't take as many photos as I should have.

Been diggging around on YouTube and found some good videos from Sled Solutions for the Skinz Air boards. WRP has one too. Really like how LCCWY has a great video on how to install there set ups. So I got an idea of what/how to do it. Brad has a few photos on his facebook page of the tunnel ready for instal. (web site is currently getting redone) Just not how he did the front next to the front foot well vent area. Any advise, photos or tips on the install would be great. Brad is away on vacation for a while soaking in the sun.

Got all the proper air tools also. grinder, cutter, air rivot hammer, tape measure, straight edge ect.

Thanks
Gumby

 

[TREE MAGNET]

Try calling Alan at Timbersled I believe he has a set on his 1100

 

[snow gumby]

That's who's sled that got me drewling. They showed up on my door step today.
Allen is a busy guy and if no one replys and I'm stumped. I'll email him for some advise.
Thanks