Ok... I have a 2012 M800 all stock motor, y pipe and pipe. With an mbrp can.
I live in Manitoba where elevation is 400m.
My clutching setup is as follows.
Team primary
-Lime green SSI 100/250 spring
-SSI adjustable weights maxed out at 86g
Stock secondary (non team style)
-Stock black/blue spring 284lb
-42/40 low elevation arctic cat helix
-Rebuilt with new rollers and bearings
I've used an arctic cat 084, Carlisle ultimate and a Dayco XTX belt. They all perform approx the same. Belt deflection is set properly.
My issue is that I'm hitting over 8300rpm even with the weights maxed out. From everything I'm reading and after reaching out to BDX via email I should not be revving this high. They say I should be using about 76-77g of weight.
What am I missing here? Something doesn't seem right.
I live in Manitoba where elevation is 400m.
My clutching setup is as follows.
Team primary
-Lime green SSI 100/250 spring
-SSI adjustable weights maxed out at 86g
Stock secondary (non team style)
-Stock black/blue spring 284lb
-42/40 low elevation arctic cat helix
-Rebuilt with new rollers and bearings
I've used an arctic cat 084, Carlisle ultimate and a Dayco XTX belt. They all perform approx the same. Belt deflection is set properly.
My issue is that I'm hitting over 8300rpm even with the weights maxed out. From everything I'm reading and after reaching out to BDX via email I should not be revving this high. They say I should be using about 76-77g of weight.
What am I missing here? Something doesn't seem right.