Orange(yellow)/blue light on pure logic box?

[shadow conspiracy]

Had to get a new pure logic box for my pump gas 1000. This box has the orange/blue setting(maybe its yellow/blue which is for the dual injectors) and my other box didn't have this setting. Just curious on what i should set it at as im going to try it out tomorrow. I tried to call OVS but its was late and no answer. Thanks for the help. I don't have the dual injectors.

 

[BigAir]

I am guessing they sent you the wrong box. It may work fine. I would leave that setting at zero (fast blink). They call it yellow/blue, but I always thought it looked more orange as well.

 

[shadow conspiracy]

my bro just got a new box for his m7t and it came with the same setting. OVS told him to set it at 4. Hes running single injectors too.

 

[Turbo Monster]

Ovs has the numbers for the box on there website. It's under pureologic boxes.

 

[DirtBoss]

(Mode 5 Yellow/Blue) On a normally aspirated engine this is the air temp offset, the higher the number the leaner or less fuel the lower the number is richer or more fuel. Turbos with secondary injectors is to add fuel for boost, this mode starts at 9psi. On Polaris this is the yellow switch point, it tells the yellow when to take over the green (lower the number the lower the rpm the higher the number the higher the rpm or switch point).

 

[WyoBoy1000]

Would not run it until I talked to OVS

 

[dubbs]

Ya yellow blue is for secondary injectors and ya they come into the equation after 9 psi... If you keep it under 9 psi which you prob will you should be fine I would think? You will need to adjust your green blue for your main injector boost fueling... Good advise not to ride it without taking to Travis but I bet you will be fine.. Would be 1 less thing to upgrade if you decide to go to a race gas kit...