S
searafter35
New member
Anybody have any tricks to get access to the oil pump. I can feel it but how do you see the marks to adjust it if necessary? Does the service manual have any ideas??
oil pump adjustment
- Thread starter searafter35
- Start date
with the carbs off, and the PTO side carb adapter off I can see it just fine. Mirror helps even more so with seeing the marks. This is on a 600HO sled obviously.
Oil pump
Check out my TECH TIPS FOR 600/700/800 CFI's Free Mods & Best Bang for the Buck Mods thread under the "INCREASING YOUR IQ "sticky" at the top of the IQ section.
There' a pic of the oil pump posted, took it when I had the engine out.
Above poster was correct, monitor the fuel/oil ratio first, then re-adjust.
Use the alignment marks ONLY as a starting point.
My 2007 DRAGON 700 was 37:1 from the factory, 1 1/4 to 1 1/2 turns on the 10 mm nuts and it's at 57:1 now, and I'm comfortable with that.
Hope this helps
Check out my TECH TIPS FOR 600/700/800 CFI's Free Mods & Best Bang for the Buck Mods thread under the "INCREASING YOUR IQ "sticky" at the top of the IQ section.
There' a pic of the oil pump posted, took it when I had the engine out.
Above poster was correct, monitor the fuel/oil ratio first, then re-adjust.
Use the alignment marks ONLY as a starting point.
My 2007 DRAGON 700 was 37:1 from the factory, 1 1/4 to 1 1/2 turns on the 10 mm nuts and it's at 57:1 now, and I'm comfortable with that.
Hope this helps
