new track problems

[bcrevitup]

just put on a 156x2.5x3" pitch on my rev added 8 tooth drivers when im going down hill or rolling to a stop sound like its binding up i thought it could be chaincase but its ok,any other ideas?

 

[Dootimes2]

What year is it. I have always had to use 7 tooth drivers to get enough clearence. Never had a problem with them.

 

[winter brew]

Sounds like a tight fit....where is it hitting?

 

[bcrevitup]

its a 06 800 adr,looks like there is enough clearance..when i started to look around my sled i noticed that i lost my secondary bolt,to me it doesnt seem to be the problem but i could be wrong.

 

[Ill Named]

you need 7t with a 2.5

 

[bcrevitup]

you need 7t with a 2.5

anybody elses thought on this,should i change it to a 7t? seems like theres about 1/2 inch clearance.

 

[Dootimes2]

As I said above 7 Tooth. I have been around alot of these and every one of them has 7 tooth drivers unless they have a drop and roll.

 

[BoondockTahoe]

As I said above 7 Tooth. I have been around alot of these and every one of them has 7 tooth drivers unless they have a drop and roll.

Been running 2.5 extreme for 3 years/ 4,000 miles with 8 tooth, no problems. Dropped skid in front 1 1/4", rear 2.5". Drivers might not be pressed on correctly, drivers should be closer to the center of the track in the windows. 2x4 and big hammer if need be, also the rivets inside the tunnel rub at times on the paddels, grind 1/8-3/16 off being sure to leave enough purchase, helped my rubbing while sidehilling firm snow. If the track is to tight it will feel like you hit the brakes when you let off the throttle, so will a new DynamoJoe clutch kit if you put it on at the same time. My $.02